|
|
|
|
|
#1 |
|
Criminally insane
Регистрация: 15.11.2008
Сообщений: 10
|
G'day Vanir
I was a bit too slow to get hold of your P-40s before they were pulled from the other site. As an Aussie I was keen to see them developed. What happened to them and where are they now? All the best, Cheers
__________________
B61- A little can of artificial sunshine |
|
|
|
|
|
#2 | |
|
Новичок
Регистрация: 26.03.2009
Адрес: Croatia
Сообщений: 19
|
Цитата:
They have a few additional features ....be sure to read txt file for instructions,and study pilot's notes carefully..sl@sh a.k.a. EnsignRo |
|
|
|
|
|
|
#3 |
|
В пожизненном отпуске
Регистрация: 15.02.2009
Адрес: Прага
Сообщений: 2,293
|
I installed the Kittyhawks well, and then tried to fly it in QMB+ on Okinawa
map. The engine quickly went out of order, rpm falled to almost zero. This was observed even after I hit "A" immediately after starting the "None-type " mission. What am I doing wrong? |
|
|
|
|
|
#4 | |
|
Новичок
Регистрация: 26.03.2009
Адрес: Croatia
Сообщений: 19
|
Цитата:
It's not your fault...or maybe it is,did you read pilot's notes?These are not QMB birds,they require engine warm up and run up .
|
|
|
|
|
|
|
#5 | |
|
В пожизненном отпуске
Регистрация: 15.02.2009
Адрес: Прага
Сообщений: 2,293
|
Цитата:
Meanwhile I uninstalled the Kittyhawks, but now I shall give them a try again, going to Scramble type QMB mission and following the pilot notes concerning the warm up. Btw, I tried before to let the birds fly AI only , and they also did not mastered them. How it is in FMB missions? |
|
|
|
|
|
|
#6 |
|
В пожизненном отпуске
Регистрация: 15.02.2009
Адрес: Прага
Сообщений: 2,293
|
Well, I gave them a try: installed again, created mission in FMB on Darwin map,
read the pilot notes, and still not be able to fly. Isn't anywhere somthing such as training mission? And the observation: when I flied for Blue side, letting Kittyhawks to start by AI only, they don't know to fly these birds. So Kittys cannot serve as targets.
|
|
|
|
|
|
#7 | |
|
Новичок
Регистрация: 26.03.2009
Адрес: Croatia
Сообщений: 19
|
Цитата:
...do it like this,works for me every time....start engine,raise rpm to 900-950 and keep them there until oil pressure reaches 70lbs...once the pressure is above 70,very slowly raise rpm (be careful,pressure drops a little when you raise rpm) untill 1700rpm's are reached...keep them there untill oil temperature raises above 45-50 deg C...then raise rpm to 2100rpm untill coolant temperature is at least 70 deg C...when it get's above 70,you are clear for take off...again,don't just slam the throttle to 110%,increase it gradualy ...
|
|
|
|
|
![]() |
| Здесь присутствуют: 1 (пользователей: 0 , гостей: 1) | |
| Опции темы | Поиск в этой теме |
| Опции просмотра | |
|
|